Gently sand the filler flat and vacuum all dust away.
Mark positions of all joists and timbers then fix.5mm plasterboards to the underside of the original joists using 38mm drywall screws.
Use thick lining paper.You wouldnt risk your eyes for a fiver would you?Your ceiling may look flat from the floor, but once you get up there and have a closer look, you will get a much better idea of its condition.Repairing Bubbles In Paper tape, quite often bubbled paper tape will not show up until the job has been painted.The epoxy will make a watertight seal in the crack.
(its a nice way to say thanks for the guide if you buy, as amazon chip in towards my coffee bill!) Not destined for the coffee table.
Just smoothing it over with spackle wont stand up because you cant get enough material in to bridge the gap.
Small areas of missing or loose plasterwork can be re-plastered, preferably using similar haired lime based mortars and plasters.Take it out and move it up or down about a half-inch and try again.Re-plastering with traditional lime based mortar and plasters A rare alternative to complete removal, is the removal of the sagging and broken plasterwork and re-plastering the original laths (assuming they are OK) with a suitable haired lime mortar and lime finish plaster.This how to explains how to carry out repairs and/or to take down a lath and plaster ceiling that you might want (and have permission) to remove.Did I mention the dust when taking down a lath and plaster ceiling?Pick axe (optional but useful for getting the old lathes down if you dont have the Roughneck).Remove the plaster using a claw hammer or similar and a stout trowel.Tools you will need Fortunately you dont need many and you may already have them in your tool kit.Paper tape stretches, so once the tape is embedded, to finish coating over, start from the center and work to each end.Clean up and vacuum all surfaces.Not a good the body code pdf repair if the plasterwork has gone beyond the cracking stage,.e.Obviously if you tackle the job in broad daylight and there are windows Ventilation Bit obvious this one, but you should open any windows if you can and dont forget your dust mask!It can then be decorated however you wish (ironically, some are painted to look distressed!?!).Make no mistake, tackling lath plaster is not a decision to take lightly and certainly not a job to attempt yourself, unless you can tolerate a heck of a lot of mess and drama for a few hours.A little give is normal but if you feel the plaster move up and down, this means that it is not attached to the laths.
Repairing limited damage or cracks in lath and plaster (ceilings and walls).
Glue sagging plasterwork back into place.
Look for signs of moisture or recent movement to determine if there are any structural issues that need to be addressed before repairing the plaster.
Click the image to see more As usual this page is a work in progress so feel free to leave comments to tell me how to do it properly Stay well.