Power Module - Wall mount power supply module (MEI-AH ED12010) - 100VAC input, 47-63Hz - 13VDC output, 800mA,.4 watts (for use in Japan) Power Module - Wall mount power supply module - 120VAC input 60Hz power supply AC DC 15W universal adapter Power module.
If the cover sensor fails, check that the front-panel assembly personal finance kapoor 4th canadian edition pdf is correctly connected to the electronics module or else replace the front-panel assembly.
If the Media sensor fails, check that the sensor cable is correctly connected to the electronics module or else replace the overdrive assembly (the media sensor is included as part of the overdrive assembly).
Once the the LEDs begin to light up one by one, release the Reprint key Entering Service Mode 2 While holding the Media Source key down, switch the printer.If a new module does not show this error, it means that it has been installed previously and was probably calibrated with other parameters.System Error: Flashing KLM - This error code indicates a severe problem which will require a Service Engineer to troubleshoot.System Error: Steady DFL - Replace the Electronics Module.A, cable - RS-232C serial cable - 25-pin (M) to 9-pin (F) -.0m (9.8ft) long.If the carriage is not moved at all, the Encoder Sensor test will always fail.Check that all LEDs are functioning correctly when they flash.Film LED - Magenta Cartridge Continuity.Apply lubricant to the slider rod.Best LED - Line Sensor.C Software - Toolbox and driver software - HP-GL/2 and RTL drivers for Windows.1/95/98/NT.0 (all DesignJets and toolbox software for Windows 95/NT.0 (Only for DesignJet 430/450C/455CA/1050C/1055CM) -.5-inch.44MB floppy disks (German) C Software - Toolbox and driver software - HP-GL/2.8 Cut the sheet along the dotted line and reload the sheet facedown into the Printer, in the direction indicated by the arrows on the calibration plot.The trailing cable may be preventing the carriage from reaching the left-hand stop.Perform the carriage-axis test and the servo/encoder test to check for problems with the carriage motor, encoder strip, and electronics module.
If not, check cartridges.
Perform Carriage Axis Test.English, copyright Hewlett-, packard Company 1 997, this document contains proprietary information that is protected by copyright.Analog Multiplexer Test Failure If the Analog Multiplexer test fails: Check and if necessary replace the Trailing Cable.6 Once you have short-circuited the two pins, the Fast, Normal and Best LEDs (LEDs ABC) should light up again.If the Spittoon is loose or mispositioned, the cutter will have problems parking in the right cover.System Error: Steady FK - Fan faulty or badly connected.The printer first performs the Front-panel Test and once it is fully completed (once all the keys are pressed) then continues with the rest of the above tests in parallel.If not, advise the customer to use HP media and check to see if the problem is now solved.Check the Capping Position in the Service Station.Keep in mind that the value printed on the service configuration plot may greatly underestimate the amount of ink in the spittoon.What can I do if the Bail Mechanism Fails?If the quality is bad, try to clean the black cartridge or replace.After initializing, error code "DLM" will appear because the Accuracy Calibration must still be performed.Check for any areas where the carriage may be binding.This can happen due to excessive wearing of parts.Remove all cartridges from the Carriage and try installing just the rejected cartridge.
Perform the accuracy calibration whenever the: eerom is erased.
The Belt is not correctly positioned over the idler pulley.
11 black ink printhead C4811A Printhead -.