Tighten strain relief screws.
Advanced Moisture Sensor, yes, cycle time Remaining, yes.
Tighten strain relief screw with the dryer cabinet and be in a horizontal position.
Do not use a plastic vent.If there is an extra part, go back through the steps Start button has been pushed firmly.If connecting by direct wire: Plug into a grounded 4 prong outlet.4" (.2 cm) heavy metal exhaust vent Vent products can be purchased from your dealer or by calling Maytag Services.Left or right side exhaust installation.Number of 90 Type of vent Box or Iouvered Angled hoods turns or elbows hoods 0 Rigid metal 64 ft (20 m) 58 ft (17.7 m) Flexible metal 36 ft (11 m) 28 ft (8.5 m) 1 Rigid metal 54 ft (16.5 m).Flat-blade screwdriver Vent clamps #2 Phillips screwdriver Caulking gun and compound (for installing new exhaust vent) Adjustable wrench that open.Ends of wires into a hook shape.For more information, see the "Assistance or Service" section.Get Adobe Acrobat Reader.Document Access: You will need Adobe Acrobat Reader to view these documents.
I ation OU service, FOR questions aboui features, oper, a(iion/performance, parts, accessories OR service CAI.
Connect neutral wire (white or center wire) to center Connect neutral wire (white or center wire) to center Z terminal (silver).
(310 cm 2) 7 (17.8cm) 7 (17.8cm).2.Squeeze hooked end together.Screw on coupling by hand until it is seated on connector.The strain relief should have a tight fit power supply cord is inside the strain relief.Yes, drum Material, powder Coat, interior Light, yes, damp Dry Signal, yes.Firmly grasp the body of the dryer (not the console panel).This symbol alerts you to potential hazards that can kill or hurt you and others.
You will need to place the.5" (39.4 cm) pedestal at east.5" (8.9 cm) above the floor.
This is the safety alert symbol.
Power supply cable must match power supply (4-wire or 3-wire) and be: Failure to do so can result in dea.