In terms of efficiency, they are diagram considered less efficient than submersible pumps.
When pressure builds up on manual the pump pressure guage, start opening regulator slowly.
Wash hands after handling.
Repair or take to motor shop.
If not, remove and examine for plugging.Motor overheats AND overload manual trips OUT.3 step 3 Install foot valve to the bottom of the jet or on the bottom of the tail pipe, if the tail pipe is being pump used.Install indoors only or in a pump house.Step 2 Deep well pumps are always installed manual with the ejector or jet attached manual to the bottom of the suction and pressure pipe in the well.Warning indicates a potentially hazardous situation which, if NoT avoided, pump CouLD result in death or serious injury.Failure to comply with instructions could result in personal injury and/or property damage!Pump starts AND stops TOO often.Risk of electric shock! .Step 3 For convertible jet pumps attach the ejector to the pump housing, making sure that the 1 1/4 and 1 tapped holes in the ejector match up with the 1 1/4 and 1 tapped holes in the pump housing.System incompletely primed.Worn or defective pump parts or plugged impeller.
Cause OF trouble HOW TO check HOW TO correct.
If the system software will not hold this pressure when the compressor is shut multiplayer off, there is a leak in the suction side.
At this point determine what your operating pressure is by reading the pressure guage.
Wrong pressure switch diagram setting or setting drift.Repeat test if necessary, pull piping assault and world repair leaks.Flammable liquids such as gasoline, chemicals, software or corrosive liquids should never diagram be used with these pumps.It crack comes with built-in pressure switches to turn itself on and off automatically as and when required.Autor: Thomas Klenck jet - pump - work, the article Jet Pump Working Principle details how the whole jet pumping system works.Leak in foot valve.Check to see that switch is closed Check switch setting.Step 5 Mount the pump onto the well adapter with gaskets and bolts, making sure that the 1 1/4 and 1 holes in pump line up with the holes in the adapter.