Figure 1 (for dimensions see page.).
LeesonboreFrameDate Code DescriptionFigureParts.(Ref.)Suffix Single Pole Normally Open Contact 1 N/A210 (New)E Double Pole, Single Throw Normally Open Contacts2.6956-140A-E Double Pole, Normally Open Contacts3.25180A-ESingle Pole Normally o Sets of Contacts (Two Switches motor per Motor)4 N/A48-140A-E Figure 2, 3, and 5 both contacts.
Drive Connections Assumptions: This drive series supplies motor voltage from its A1 and A2 terminals.
To calibrate, turn the leeson motor speed adjust potentiometer full CCW.If for any reason any of the forgoing provisions shall be ineffective, leesons liability for damages arising out of its manufacture or sale if equipment, or use thereof, whether such liability is based on warranty, service contract, negligence, strict leeson liability in tort, or otherwise, shall not.Remove the blown fuse and replace manual with a new fuse.Follow the National Electrical Code and all other applicable electrical and safety codes, including the provisions of the Occupational Safety and Health Act (osha when installing equipment.Limitations of Liability - In the event of any claim or breach of any of leesons obligations, whether expressed or implied, and particularly of any claim of a breach of warranty claimed in Paragraph A, or of any other warranties, express, or implied, or claim.Dynamic leeson braking service Dynamic braking may be used to rapidly stop a motor (Figure 9, page 13).(5 mm) wide slots in the chassis accept #8 pan head screws.Wire the collector to H1, and the emitter.
Leeson strongly recommends the pathfinder installation of a master switch in the main power input to stop the drive in an emergency.
This Product Ships prepaid and ADD Only!
The fuse does not manager have to be resized as long as the motor used is within the drives specified horsepower range.
Leeson Electric assumes no responsibility for any errors that internet may appear in this manual and makes no commitment to update or to keep current the information in this manual.Your assessment is very important for improving the work pathfinder of artificial intelligence, which forms the content of this project Related manuals Do you need a help?Check that the MIN SPD pathfinder and MAX SPD setting are not set too high.Mount the drive away from heat sources.Figure 13 shows the connection of two independent speed adjust potentiometers that can be mounted at two separate operating stations.TEL: (262) FAX: (262) Document number 2500256, Rev.An isolated NPN open-collector transistor rated for at least 10 mA (ICE) may also be used as an inhibit switch.Ending With 48/56 nissan nema Frameleesondate Code"A" Dim."B" Dim."C" silient manager Part.003569.010.553 Endshield oseendshield SE* Date Codeleesonleeson For FrameEnding withPart NumberDescriptionPart NumberDescription RigidA, B,E (203 brg)7/8" Conduit Hole AC motors Endshield oseendshield SE* Date Codeleesonleeson For FrameEnding withPart NumberDescriptionPart NumberDescription RigidA, B,E Endshield oseendshield SE* Date Codeleesonleeson For FrameEnding withPart NumberDescriptionPart NumberDescription 48 tefc RigidA, B,E.
Have a qualified electrical maintenance technician install, adjust, and service this equipment.
Make no connection.