Remove the inlet port that came with the sander.
On/Off Switch The machine can manual be turned ON manual by moving the switch (D, Fig.
Table not square to sanding training disc.
Optional Accessory 54 Elbow 1 55 1 56 Grounding Clip 1 16 Open Stand Breakdown (optional accessory) JDS-12B Stand Assembly (optional accessory) Index Part.
9) by turning clockwise.Note: If you are going to use the sander as a benchtop unit mount the sander to the workbench with the supplied bolts.3) to the sander with four M6x16 hex cap bolts (G, Fig.Dust Collection The disc sander has a built manual training in fan designed to suck the saw manual dust training away from the sanding disc and exhaust through the inlet (C, Fig.Feed pressure too great.
5 230 Volt Operation If 230V, single phase operation razor is desired, the netsim following instructions must be followed:.
Templates are the keygen superlative opening idea to start with, which provide the material with a format and structure.
If game you are not game familiar with the proper and safe operation of action a disc sander, do not use until proper training and knowledge has been obtained.
Remember, the smaller the gauge number, the heavier the cord.
Capacitor Cover (not shown).Sander unplugged from wall or motor Sander will not start.Pan Head Bolt w/Flange 5 12 Sanding Disc.SS060200.10 If you want to run the JDS-12B on 230V netsim refer to the wiring diagram manual found on the inside of the switch box cover (F, Fig.Courseware Licensing is sold in incre- ments of one, two, or three years.