Fibaro Roller Shutter 2 allows for connecting push buttons to the S1 and S2 terminals.
Verify correctness of connection, arrange the device and its antenna in repair manual for 2005 nissan maxima a wall switch box.
Length of wires used to connect the control switch should not exceed 20m.
Holding up button connected to the S1 terminal initiates slats rotation.Response to Flood Alarm Available settings: 0 no reaction 1 open blind 2 close blind Default setting: 0 Parameter size: 1 byte.Available settings: 0 function is disabled 1-65535 (1-65535s) Default setting: 240 (4 minutes) Parameter size: 2 bytes.KS, klick System, brochure, cKS, corded Klick System, brochure, cS, contract System, brochure, dS, design System, brochure, fES, forest Easyfold System, brochure, pS, panel System.Motor operation detection Power threshold to be interpreted as reaching a limit switch.Scenes/associations activation Parameter determines whether scenes or associations are activated by the switch buttons.It is not recomended to control all Roller Shutters in this mode.Adjusted Smart FAN curve.
Installation of the device: Switch off the mains voltage (disable the fuse).Consumers of electricity in households are billed by suppliers on the basis of active power used in given unit of time.Available settings: 0 reaching a limit switch will not be detected 1-255 (1-255W) Default setting: 10 (10W) Parameter size: 1 byte.Available settings: 0 gate will not close automatically 1-255 (0.1-25.5s,.1 step) Default setting: 10 (1s) Parameter size: 1 byte.If necessary, calibrate the module, wiring diagrams: Roller Shutter wiring diagram, connecting Roller Shutter to gate motor.These may be momentary or toggle switches, alternatively.Date, size 1 M, description, checksum:4E9Bh Date:2011/10/06.Fibaro Roller Shutter 2 allows precise positioning of roller blinds or venetian blind lamellas.The device should be installed in a wall switch box compliant with a relevant national safety standards and with depth no less than 60mm.The parameter defines a change that needs to occur in order to trigger the report.
Its not recommended to use the device at the range limit.